• If the LED is on continuous red, the batteries must be charged immediately . The chair
can then no longer be used .
• Connect the charger to the Elexo XXL (See figure 11) .
• Once the charger is connected to the Elexo XXL, the controls will go into 'sleep' setting
(all functions are switched off) .
Make sure that you push the plug into the correct position in the charging point.
Only the original charger for the Elexo XXL may be used. If you use another
charger, Lopital cannot be held liable for any consequences, such as damage to
the electronics.
Once the charger is connected to the Elexo XXL, the controls will go into 'sleep'
setting (all functions are switched off).
The charger that must be used for the Elexo XXL is the 'Mascot 2241'.
• When the indicator light on the charger goes green, the batteries are charged . The
charger can remain connected even when the batteries are completely charged .
Leaving it connected will not cause any damage .
• Disconnect the Elexo XXL from the charger .
• Once activated, the Elexo XXL is now ready for use (See paragraph 2.2 Activating) .
LEDs not on:
Green light is on:
Orange LED is on:
Orange led blinks: emergency stop has been activated .
Red light blinks:
Red LED on:
Charge batteries in a well-ventilated, dry space.
After using the chair, connect it to the charger to maintain the batteries. Charge
the chair at least once a week!
For instruction videos go to www .lopital . c om or www . y outube . c om/user/LopitalNL
Chair is in 'sleep' setting and
cannot be used .
Chair is ready for use .
Batteries need charging
or batteries are partially
charged .
Batteries must be charged (chair can still be used) .
Batteries are completely empty and must be charged immediately .
Elexo XXL Shower-toilet chair | Instructions for use | 33
Figure 12 Battery indication on handcontrol .