Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.14
Alarm memory
48 hours alarm memory function. When the device detects CO and alarms, when the device returns to standby
mode, and the CO concentration <20PPM, LCD displays "AL" and ALARM indicator (red) flash per 40 seconds. After
press TEST/SILENCE button or after 48 hours, will reset the historical memory function and enter normal operation
status.
4.
WHAT TO DO IF THE ALARM SOUNDS
WARNING! Actuation of your CO alarm indicates the presence of Carbon Monoxide (CO) which can KILL YOU.
Keep calm and open all doors and windows to increase the rate of ventilation. Stop using all fuel-burning appliances
4.1
and ensure, if possible, that they are turned off, e.g., for gas appliances, isolate the emergency control valve.
If the alarm continues to be activated, then evacuate the premises. Leave the doors and windows open, and only
4.2
reenter the building when the alarm has stopped. In multioccupancy and multi-story premises, ensure that all the
occupants are alerted to the risk.
4.3
Get medical help for anyone suffering the effects of carbon monoxide poisoning and advise that carbon monoxide
inhalation is suspected.
4.4
Telephone the appropriate appliance servicing and/or maintenance agency or, when necessary, the relevant fuel
supplier on their emergency number or the national Gas Emergency Service Provider, if appropriate, so that the
source of carbon monoxide emissions can be identified and corrected. Unless the reason for the alarm is obviously
spurious, do not use the fuel-burning appliances again, until they have been checked and cleared for use by a
competent person according to national regulations.
5.
BATTERY INSTALLATION/REPLACEMENT
Once chirps with corresponding FAULT indicator (yellow LED)
flashing once every 40 seconds indicates that the battery is low
battery, you must replace with battery specified, please see
"8. SPECIFICATIONS
please perform the following steps:
5.1
Take down the unit from screw heads of the wall.
5.2
Open battery compartment.
5.3
Remove the old batteries and replace by new batteries.
5.4
Put the battery into the battery box.
5.5
Hook the alarm over the screw heads onto keyholes at the back
of the unit.
5.6
Test alarm using the TEST/SILENCE button, if the testing alarm is
ok, means the product can work normally.
WARNING! Use only the battery specified. Use of different
battery may have a detrimental effect on the CO alarm. A good
safety measure is to replace the battery at least once a year.
CAUTION: Please replace new 2pcs same type batteries in the
meantime.
CAUTION: Test the alarm for correct operation using the
TEST/SILENCE button, whenever the battery is replaced!
6.
GENERAL MAINTENANCE
To keep your CO alarm in good working order, please follow these simple steps:
6.1
Verify the unit's alarm sound and indicators operation by enable the TEST/SILENCE button once a week.
Remove the unit from the wall and clean the alarm cover and vents with a soft brush attachment once a month to
6.2
remove dust and dirt.
6.3
Never use detergents or other solvents to clean the unit.
6.4
Avoid spraying air fresheners, hair spray, or other aerosols near the CO alarm.
Do not paint the unit. Paint will seal the vents and interfere with the sensor's ability to detect CO. Never attempt to
6.5
disassemble the unit or clean inside. This action will void your warranty.
". To install or replace the battery in unit,
- 6 -
Advertenties
Inhoudsopgave
