Download Inhoudsopgave Inhoud Print deze pagina

Replacing The Lamp; Closing The Door - AEG S53600CSS0 Gebruiksaanwijzing

Verberg thumbnails Zie ook voor S53600CSS0:
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Problem
The temperature in
the refrigeration is
too high.
The temperature in
the freezer is too
high.
The appliance does
not operate.
The lamp does not
work.
If your appliance is still not working
properly after making the above checks,
contact the After Sales Centre.

7.1 Replacing the lamp

2
1

7.2 Closing the door

1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
Possible cause
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The appliance is equipped with a longlife
LED interior light.
1.
2.
3.
4.
5.
6.
7.
3.
Solution
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
Close and open the door.
Refer to "Replacing the
lamp".
Disconnect the appliance.
Push the movable part to unhook the
lamp cover (1).
Remove the lamp cover (2).
If needed replace the lamp with a
light of similar characteristic and pow-
er. It is suggested to use Osram PAR-
ATHOM SPECIAL T26 0.8 Watts.
Install the lamp cover.
Connect the appliance.
Open the door. Make sure that the
lamp comes on.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
35

Advertenties

Hoofdstukken

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

S53600csw0

Inhoudsopgave