Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
LED indicator
Red, continuous
Red, flashing
Red, flashing rapidly
Green, continuous
Note:
The LED indicator does not operate when the door of the appliance is opened.
CHANGING THE PROGRAM
You can change the program while the appliance is running.
1. Carefully open the door to avoid water spillage.
2. Use the program selector button to choose another program.
3. Close the door.
The newly selected program will resume the course of the previously selected program.
DELAYING THE PROGRAM
Note:
The start time of a program can be delayed for a maximum of 19 hours.
1. Push the timer button to delay the start time of a program. Every time you push the button the timer increases by
1 hour.
2. Push the timer button again to change the time or cancel the timer.
3. Close the door to activate the timer.
The program will start when the timer has finished.
RESETTING THE PROGRAM
You can reset the program while the appliance is running.
1. Carefully open the door to avoid water spillage. The display shows the selected program.
2. Push and hold the program selector button for 3 seconds. The display shows 1.
3. Close the door to let the appliance drain the water inside. This takes about 30 seconds.
A buzzer sounds five times when the program is cancelled.
STOPPING THE APPLIANCE
Note:
The appliance is silent for 40 to 45 minutes during the drying process.
Note:
A buzzer sounds five times when the program is finished.
1. Open the door.
2. Wait a few minutes before you unload the appliance. The dishes are very hot and can break.
3. Push the on/off button to switch off the appliance.
State of the appliance
The appliance is running a program.
A program is cancelled.
The appliance has an error. Refer to section
codes
.
A program is finished.
Fault
English
•
47
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
