Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3
before first use
Prior to using the machine for the first time please check whether the electricity and supply water specifications match the values
indicated by the installation instructions for the appliance.
Remove all packaging materials inside the machine.
Fill the salt reservoir and fill up with water until it almost overflows. Set the water hardness setting.
Fill the rinse aid reservoir.
FILLING THE SALT RESERVOIR
For a good washing result, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white lime residues will remain on the
dishes and the interior of the dishwasher. This has a negative effect on your applinace's washing, drying and shining performance. For
this purpose, dishwasher salt is used.
• Remove the lower basket and unscrew the cap of the salt reservoir (1 and 2).
• Fill the reservoir before first use with 1 litre of water (3). Place a funnel into the opening
and fill with salt till the overflow level (4). It is normal for a little water to flow out of the
opening when doing this.
• Screw the cap back on firmly.
ATTENTION!
• Remove any spilled salt and run a full program to prevent corrosion to the bottom.
• Refill the salt reservoir when the indicator light of the salt reservoir lights up.
SETTING THE SALT CONSUMPTION
To find out the water hardness level in your area, contact your local water company. Adjust the salt consumption according to the
table on the next page.
Note! Hardness level is adjusted to level 3 as a factory setting.
• Move the program selector knob (1) to the setting off ● while the dishwasher is not on.
• After setting the program selector knob to off ● , press the Start/Pause button (2) and keep it pressed down.
• Turn the program selector knob to the first program Rinse while still pressing the Start/Pause button (2).
• Keep the Start/Pause button (2) pressed down until the indicator lights turn on and off.
• After the indicator lights (3) lit up, release the Start/Pause button (2).
The control panel shows the latest entered water hardness setting.
• Set the level of water hardness by pressing the Start/Pause button (2). Use the table of water hardness level settings on the
next page.
• After adjusting the level of water hardness, turn the program selector knob back to the setting off ● to confirm and store the
setting.
30
•
English
●
3
1
2
Advertenties
Hoofdstukken
Inhoudsopgave
