Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The articulated-arm awning must not be extended for 15
seconds after retraction.
9. Programming the initial angle of inclination (optional)
The articulated-arm awning must be completely still when
programming the initial angle of inclination.
1. Extend the articulated-arm awning to the limit position.
2. Turn off the power to the system.
3. Open the controller.
4. Press the programming button for at least 10 seconds until the LED goes
from green to red briefly and then back to green.
5. Close the controller.
6. Now turn the power to the system back on.
This completes the programming process.
Switching off the angle of inclination
1. Extend the articulated-arm awning to the point where you can reach the
SC211-II.
2. Turn off the power to the system.
3. Open the SC211-II and carefully remove the PCB.
4. Turn the rotary switch to position 0.
5. Slide the PCB back into the SC211-II.
Ensure that the PCB is completely pushed in. After
3 seconds, the controller is ready for operation again.
6. Then press the red button until the LED lights up green briefly.
7. Close the SC211-II.
8. Now turn the power to the system back on.
This completes the process.
Changing the angle of inclination
1. Extend the articulated-arm awning to the limit position.
2. Turn off the power to the system.
3. Set the new release angle (see "Setting the release angle").
4. Now programme the initial angle of inclination (see "Programming the initial
angle of inclination").
This completes the process.
25 - en
Advertenties
Hoofdstukken
Inhoudsopgave
