The SC211-II is intended solely for the operation of an open, half-closed
(semi-cassette), or fully closed (cassette) articulated-arm awning.
For safety reasons, the SC211-II must only be operated with a tubular drive
(diameter of 45, 58) with model name C12 or C12 PLUS ... as well as VC420-II
or VC470-II. The operation of two or more articulated-arm awnings with one
SC211-II is not permitted.
The SC211-II is compatible with the Centronic SunWindControl SWC241-II
hand-held transmitter. Operation using other sun protection controls from the
Centronic range is not recommended.
Attention
After the end of the season or before the sun protection sys-
tem is to remain unused for an extended period of time (e.g.
winter), remove the batteries so as to avoid damage due to
leaking batteries.
Using the switch for any other purposes or for purposes beyond the above
constitutes improper use.
• Please note that radio-controlled systems may not be used in areas with
a high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and sys-
tems in which malfunctions in the transmitter or receiver would not pose
any risk to persons, animals or property, or which contain safety devices
to eliminate such risks.
• The operator is not protected from interference from other telecommu-
nications systems and terminal equipment (e.g. even from radio-con-
trolled systems which are properly operated in the same frequency
range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
•
Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
•
Note that the range of the radio signal is limited by legis-
lation as well as by design.
Intended use
19 - en