Download Inhoudsopgave Inhoud Print deze pagina

Cleaning; Replacing The Spool (Fig. D) - Parkside PRTA 20-Li D3 Vertaling Van De Oorspronkelijke Gebruiksaanwijzing

Grastrimmer met accu 20 v
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

˜ Cleaning and maintenance
m
WARNING! Risk of injury!
Always switch the product off,
remove the battery
the product cool down before
performing inspection, maintenance
or cleaning works .
m
WARNING!
Risk of injury from moving dangerous
u
parts!
m
CAUTION!
Any maintenance and repair other than
u
described in this manual: Contact an
authorised service centre or a similarly
qualified person to check or repair the
product . Only use original parts .
NOTE
The following cleaning and servicing
u
should be done regularly . This will ensure
a long and reliable service life .
˜ Cleaning
m
WARNING! Risk of electric shock!
Do not spray the product with water and
u
do not immerse it in water .
NOTE
Do not use cleaning agents or solvents .
u
You may otherwise irreparably damage
the product .
Be careful with the line cutter 
u
cause serious lacerations .
and let
17 ]
[
. It can
24 ]
[
Keep clean the ventilation slots, motor
o
housing and handles of the product . Use a
damp cloth or a brush .
After every trimming session, remove grass
o
and soil from the protective cover 
the trimming assembly .
˜ Maintenance
NOTE
Prior to every use, check the product for
u
obvious defects such as loose, worn or
damaged parts .
Check covers and safety devices for
u
damages and correct installation .
Replace as necessary .
Replacing the spool (Fig. D)
NOTE
The rotation direction of the line spool 
o
is indicated in the spool cap 
the spool . The arrows on the cover of
the spool cap indicate the direction of
rotation of the motor .
Check the line cutter 
o
the product without a line cutter or with
a defective line cutter . If the line cutter
is damaged, be sure to contact the
customer service center .
1 . Remove the battery 
2 . Press the two releases 
open the spool cap .
3 . Remove the cover of the spool cap . Take
out the line spool .
4 . Press the thread ends of the new spool out
of the spool slots 
22 ]
[
5 . Insert the new spool into the spool cap .
The side of the spool on which the rotation
direction is indicated by arrows, must be
visible after insertion .
and
[
12 ]
14 ]
[
on
13 ]
[
. Never use
24 ]
[
from the product .
17 ]
[
simultaneously to
[
20 ]
.
GB/IE/NI
21

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Hg10037

Inhoudsopgave