Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
*Getting to know your
appliance
The instruction manual is the same for various different
y o u r a p p l i a n c e
G e t t i n g t o k n o w
hobs. You can find the hob dimensions in the overview
of models. ~ Page 2
The control panel
Displays
Heat settings
‚
-
Š
Residual heat
•
/
œ
Controls
Primary switch
#
Child safety lock
‚
Hotplate selection
$
Adjustment fields
A @
Notes
When you touch a symbol, the respective function is
■
activated.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
Do not pull pans close to the displays and sensors.
■
The electronics could overheat.
Residual heat indicator
The hob has a two-stage residual heat indicator for
each hotplate.
If
appears in the display the hob is still hot. It may be
•
used, for example, to keep a small meal warm or to
melt cooking chocolate. As the hotplate cools down
further, the display changes to
until the hotplate has cooled sufficiently.
. The display remains lit
œ
Getting to know your appliance
1Operating the appliance
In this section, you can find out how to set the hotplates.
p l i a n c e
O p e r a t i n g t h e a p
The table shows heat settings and cooking times for
various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: Touch the
sounds. The indicator light above the main switch and
the
displays light up. The hob is ready for use.
‹
To switch off: Touch the
above the main switch and the displays go out. All
hotplates are switched off. The residual heat indicator
remains on until the hotplates have cooled down
sufficiently.
Notes
The hob switches off automatically if all hotplates
■
have been switched off for more than 20 seconds.
The settings remain stored for 4 seconds after the
■
hob has been switched off. If you switch it on again
during this time, the hob will operate using the
previously stored settings.
Setting a hotplate
Use the + and - symbols to set the desired heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat
setting. This is identified by a dot.
symbol. An audible signal
#
symbol until the display light
#
en
27
Advertenties
Hoofdstukken
Inhoudsopgave
