Advertenties
Beschikbare talen
Beschikbare talen
Refilling oil
To ensure that the tool remains operational for a long time, the tool
must have a sufficient fill of pneumatic oil.
You have the following options:
♦
Attach a maintenance unit with an oiler to the compressor.
♦
Install an add-on oiler in the compressed air line or the com-
pressed air tool.
♦
Add 3–5 drops of pneumatic oil into the connector nipple
after every 15 minutes of operation.
Connecting to a compressed air source
NOTE
►
Before connecting the compressed air source,
–
the correct working pressure (3–6,3 bar) must be fully
reached, and
–
make sure that the trigger is in the upper position.
►
Use only connection hoses with an internal diameter of at least
9 mm.
►
Use only filtered, lubricated and regulated compressed air.
♦
Wrap the Teflon tape
you screw it into the compressed air tool. Wrap the tape as tightly
as possible around the thread. This lowers the probability that air
will escape and it optimises the work process.
♦
Screw the connector nipple
connection with the aid of a 14 mm open-end wrench.
♦
Attach the tool to a compressor by connecting the connector
nipple
with the supply hose of the compressed air source.
│
GB │ IE │ NI
■
18
around the connector nipple
into the air inlet
before
. Tighten the
PDSS 16 A1
Advertenties
