Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ASSEMBLY INSTRUCTIONS
Before beginning assembly, be sure to observe our
recommendations and safety instruction. Remove all the
part of your cycle from the carton and place them on the
floor carefully. Some parts are pre-assembled. Assembly
time: 30 - 40 min.
Part „A" serves as a transport safety device and it is no need
after build up.
STEP 1
Attach the front and rear stabilizer (2+3) at mainframe (1).
1. Attach the rear stabilizer (3) assembled with 2 rear caps
(12) and adjustable feet (20) to main frame (1), using 2 allen
head bolts (17), 2 washers (19) and 2 spring washers (18).
You can use adjustable feet (20) to level the bike at uneven
floor.
2. Please dismount the plastic protection from front side of
main frame and use the screw materiel for assembly the front
foot. Attach the front frontstabilizer (2), mounted with 2 front
caps with transportation roller (11), to the base frame (1) so
that the transport rollers point to the front and screw it using
the carriage bolts (13), washers (14), spring washers (15)
and cap nuts (16).
STEP 2
Attach the pedals (9R+9L) at pedal crank (10L+10R).
1. Attach the pedal straps (90R+90L) to the appropriate
pedals (9R+9L). Attention! The end with many adjustable
holes must be set outwards.
2. The pedals (9R+9L) are marked with „R" & „L". Right and
Left is specified as viewed seated on the machine during
training. Connect each pedal (9R+9L) to the matching pedal
crank (10R+10L) (Attention! The right pedal (9R) should
be threaded on clockwise. The left pedal (9L) should be
threaded on counter-clockwise.)
STEP 3
Attach the seat (7) and seat post (6).
1. Slide the plastic collar (34) to cover the seat post
(6). Insert the seatpost (6) to seat post mounting tube of
mainframe (1) and secure inposition with the seat post quick
release (32).
2. Place the saddle (7) with the seat surface downwards.
Place the saddle bracket (7a) on the upwards pointing bottom
of the saddle (7). The threaded pieces on the bottom of the
saddle must project through the corresponding holes in the
saddle bracket (7a). Place washers (19) on the threaded
pieces, screw on nuts (72) and tighten firmly.
3. Put the clamp of seat (7) to the seat slide (38) and tighten
the seat firmly into your desired position. To do this, tighten
the black nuts on both sides.
4. Place the seat slide (38) on the seat post (6) and adjust
your seat (7) horizontally to your desired position. Secure this
position with the washer (14) and star grip nut (35) on the
fixed bracket (36).
A
12
20
19
3
90L
9L
7
38
14
35
1
16
89
88
1
13
2
17
18
88
90R
10R
9R
72
36
7A
6
7
88
34
32
GB
16
15
14
11R
19
Advertenties
Inhoudsopgave
