Wind Threshold Regulator (In Connection With A Suitable Sensor From The Controller Manufacturer); Test Mode; Factory Default Settings - Becker Centronic SunWindControl SWC241-II Montage- En Gebruiksaanwijzing

Handzender voor windbesturing

Inhoudsopgave

Advertenties

Beschikbare talen

Wind threshold regulator (in connection with a suitable

sensor from the controller manufacturer)

You set the wind threshold value with this regulator (between about 2 m/s and

22 m/s).

The wind threshold value can be adjusted in 11 steps. When slowly turning the

regulator, the tubular drive clicks to indicate the setting changes.

- Left stop

+ Right stop

Changes made to the threshold value are transferred immediately.

When setting the threshold, ensure that no button is

pressed. When the wind speed exceeds the set wind

threshold value, the sun protection system retracts and re-

mains closed. The sun protection system can only be exten-

ded again after the wind speed has remained below the

threshold value for approx. 15 minutes.

The TEST mode is activated by adjusting the threshold value. It automatically

ends after about 15 minutes. In TEST mode, the time for which the wind is

monitored is shortened.

Wind threshold value

Stage 1, retract at low wind

Stage 11, retract at very high wind

Left stop (about 2 m/s)

19 - en

Inhoudsopgave

Advertenties

Hoofdstukken

Inhoudsopgave