Automatic needle threader
C
1
2
3
4
B A
D
E
Attention:
Turn power switch to "O" before
threading the needle.
Important:
Raise the needle to its highest position
by turning the hand wheel toward you
until the mark (A) matched with the line
(B) on the machine.
1. Lower the presser foot.
Pass the thread around the thread guide
(C).
2. Press the lever down as far as it goes.
The needle threader turns automatically
to the threading position and the tiny
hook pin passes through the needle eye
(D).
3. Take the thread in front of the needle and
make sure it is under the hook pin (E).
Then hold the thread slightly upwards so
that it hangs on the hook.
4. Hold the thread loosely and release the
lever slowly.
The hook will turn and pass the thread
through the needle eye forming a loop.
Pull the thread through the needle eye.
Getting ready
GB / IE / NI
89