Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Prior to initial use
Overflow protection
Switching on
Stopping or changing a wash cycle
Attention:
• Always fill the salt reservoir and adjust the water hardness setting
before using the dishwasher (see page 15).
• Also fill the rinse agent reservoir and the detergent reservoir (see
page 16, 17 and 18).
Your dishwasher is equipped with a safety device which prevents the
dishwasher from being overfilled with water. The safety device closes
the intake valve and assures that the dishwasher pumps out the excess
of water. When there is water inside the diswasher (because too
much water is pumped in or in case of a leakage), the water has to be
removed before you switch on the dishwasher again.
1. Open the door of the dishwasher.
2. Check if the plug of the connecting cord is in the socket.
3. Check if the water supply is turned on.
4. Load the dishwasher (see "loading the baskets").
5. Pour in the detergent.
6. Close the door.
7. Press the On/Off button to switch on the appliance. The indicator will
light up when the machine is switched on.
8. Press the desired washing program selector button to select the
washing program. The indicator of the selected program will light up.
1. Press the button of the running progam for more than 3 seconds to
cancel it.
The machine will be in stand by state.
2. Select the new desired washing program with the program button.
The new progam will start running after 10 seconds.
3. You can also directly change the program by pressing for more
than 3 seconds the button of the new desired program.
The new progam will start running after 10 seconds.
EN 11
Advertenties
Hoofdstukken
Inhoudsopgave
