Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
To remove the blade guard (FS7000 D,
FS7000 DL, 20-42 in.)
1. Disconnect the water hose (A) from the blade guard.
C
A
2. Use the blade shaft wrench to turn the blade guard
lock (B) forward until it stops and disengages.
3. Lift the blade guard at the handle (C).
To remove the blade guard (FS7000
DL, 48-60 in.)
1. Disconnect the water hose from the blade guard.
2. Remove the bolt that holds the blade guard.
3. Remove the blade guard.
Product configuration for different blade
dimensions
A product with a 1-speed gearbox operates with 1
specified blade dimension and 1 specified blade guard.
A product with a 3-speed gearbox operates with a
specified range of blade dimensions in 1 specified blade
guard. If you replace the cutting blade with a cutting
blade of a different dimension, it is necessary to change
the configuration of the product.
For a product with a 1-speed gearbox, replace these
parts with parts of the applicable dimension for the new
cutting blade:
•
Blade shaft pulleys
•
Gearbox pulleys
•
Blade shaft flanges
•
Belts
•
Blade guard
1223 - 002 - 09.07.2019
B
For a product with a 3-speed gearbox it is sufficient to
change the gear if the dimension of the new cutting
blade is in the same dimension range as the replaced
cutting blade. If the dimension range is different, it is
necessary to replace the parts in the list also on a
product with a 3-speed gearbox.
Let your dealer help you to send an order for the parts
that is necessary for your configuration.
To do a configuration of the gearbox
•
To change gearbox setup on the control panel
display, refer to the operator's manual for the control
panel.
Configuration of a 1-speed gearbox model
There are 5 possible configurations for a 1-speed
gearbox product:
FS7000 D, mm/in.
500/20
650/26
750/30
900/36
1000/42
–
–
Refer to the operator's manual for the control panel for
more information.
Configuration of a 3-speed gearbox model
There are 4 possible configurations for a 3-speed
gearbox product:
FS7000 D, mm/in.
350–650/14–26
500–750/20–30
500–900/20–36
650–1000/26–42
Refer to the operator's manual for the control panel for
more information.
To change gears on a 3-speed gearbox model
CAUTION: Do not change gears when the
engine is on or before you do a check of the
product configuration. There is a risk of
damage to the gearbox.
FS7000 DL, mm/in.
500/20
650/26
750/30
900/36
1000/42
1200/48
1500/60
FS7000 DL, mm/in.
500–900/20–36
650–1000/26–42
750–1200/30–48
900–1500/36–60
19
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
