Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
General use
Opening the fire door
Pull the door handle towards you to open the door and push it away from you to close it. The exterior of the
stove can become very hot. We recommend using the heat resistant gloves or the operating handle.
The appliance can only be used when the fire door is closed. Once in operation, the fire door may only be
opened briefly to charge wood.
Ash door
The ash door must remain closed during operation. Otherwise air will enter the combustion chamber through
the ash door in an uncontrollable manner. The ash door may only be opened for the removal of ashes. Pay
attention to the heat and use the heat resistant gloves.
Controlling combustion air
Combustion air is adjusted by means of the thermostatic control
at the back of the appliance. The air supply is also adjusted with
the help of the sliders above the fire door and the slider between
the ash door and fire door.
Lighting
Set the air supply to its maximum capacity when lighting the fire (thermostat in position 8).
1.
Open the fire door and place a fair amount of kindling on the wood grill.
2.
Add 2 to 3 firelighters, spread over the kindling wood, in the front and at the back.
3.
Then add a few small logs on top.
4.
Now light the firelighters.
5.
After the stove has been lit, the fire door must be firmly closed.
6.
NOTE Do not open the fire door or the ash tray except when adding more wood.
If there is still a backdraught of flue gases 15 minutes after lighting because of the weather conditions (strong
wind or fog, for example) the fire should be extinguished until the weather improves.
34
Advertenties
Inhoudsopgave
