Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
FAULT FINDING
First identify exactly why the machine stopped.
The machine will not start:
Check : the mains supply, the condition of the supply cord and plug,
Check that the On/Off lamp (6) lights up when the switch is at position "1-On". If it
does not, replace the switch
With the switch on position "0-Off", check that the cone (2) can be easily rotated by
hand.
o If the cone does rotate, have the capacitor and the motor checked by a
person qualified to do so.
o If the cone does not rotate, have the clutch checked.
The appliance stops after the motor has overheated:
(the motor unit is hot)
The motor is protected by an integrated thermal cut-out system. If it overheats the motor
stops.
Put the On / Off switch (6) to the "0-Off", position and unplug the machine.
Wait for the motor to cool down (25 to 45 minutes) then press the On / Off switch (6)
("1-On" position).
If the problem persists, switch off the power supply to the machine (unplug the cord from
the mains socket) and call in the maintenance service or contact a SANTOS approved
dealer.
The appliance stops following an overload:
If the motor stalls during operation, release the pressure on the lever to allow it to
start again.
If the problem persists, switch off the power supply to the machine (unplug the cord from
the mains socket) and call in the maintenance service or contact a SANTOS approved
dealer.
The motor operates but the cone does not rotate:
Check the condition of the cone (2) drive pin (9) (Fig. D)
Check that the clutch operates correctly (Fig. E) :
o Start the appliance, with the switch at position "1-On"
o Raise the lever
o Place the cone on the motor shaft (do not put any fruit on it)
o With a piece of wood, press on the central part of the cone. The cone should
move downwards a few millimeters and start to rotate.
o If it does not, have the clutch checked.
408006-013-070-106-170 en ma 2010.12
8/13
Advertenties
Hoofdstukken
Inhoudsopgave
