Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1. INTRODUCTION
This operation manual has been designed to facilitate the use of your single door cooler with maximum efficiency
over the years. In all of the manufacturing processes "environmentally friendly" technologies are used as well
as materials and refrigerants that are not harmful to the nature. Please read this manual carefully before you
start operating your cooler in order to prevent user defects and ensure maximum efficiency from this product
that has been manufactured to serve you over the years.
Detect the cooler immediately on delivery for any damage. In case of any damage, contact with your authorized
dealer within 24 hours.
Attention: it requires a lapse of minimum 2 hours after any transportation before you start operating your cooler.
If the cooler has remained in an environment where the temperature was below 0°C for a long period, allow for
the compressor temperature to reach beyond +5°C before re-operating the cooler.
2. PRECAUTIONS AND SAFETY INSTRUCTIONS BEFORE THE INITIAL START-UP
Your cooler must be plugged certainly in an earthed wall socket.
Before operating the cooler, ensure that the mains socket is checked for proper earthing (grounding) and nominal
voltage and frequency requirements by the authorized service staff or a qualified electrician. If the supply cord
is damaged, it must be replaced by the manufacturer, or its authorized service or a similarly qualified person in
order to avoid any hazard.
Do not use multi socket and extension cable.
The main power supply to which the cooler is connected must have a leakage current relay.
The nominal voltage and frequency requirements for the body are specified on the data plate.
Never make any repairs or carry out maintenance while the cooler is plugged in the mains socket.
Do not position the cooler in a place close to a source of strong heat or exposed to direct sunlight. Always
remember that the UV lights in the sunlight deteriorates products in the glass door cooler. The appliance can be
used in ambient temperature of max 32°C.
Unless otherwise stated, do not place your cooler to open areas where water can leak in.
Do not wash with pressurized water or hose when cleaning the product and its surroundings, use a wet cloth.
Otherwise, the water which may intrude into the electrical components of the product can cause electric shock
and fire risk.
Do not place your products in highly humid placed and/or places subject to corrosion.
Start the cooler on a level surface. Position in on the floor and make sure that it is level using a bubble gauge.
If the cooler is found to tilt in one particular direction, please adjust the height of the corresponding leg until
it is level. Then please move the cooler to the location where it will be used.
Do not relocate the cooler or move the cooler on its rollers while its loaded with product. If cooler is empty,
please do not push the cooler to pass over cables or door frames, to avoid roller damages. Never push the
cooler when the pavement is uneven, having inclination, or there are stairs nearby.
All the components that produce heat are located at the bottom part of your cooler except the models S56SC
and S88SC. These models have the heat producing components on the top.
Proper air circulation at this part is very important to ensure performance, therefore while positioning the cooler,
allow minimum 10cm of space from the sides.
3
www.combisteel.com
Advertenties
Inhoudsopgave
Probleemoplossen
