Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Assembly and Operating Instructions
Programming the remote control
1. Connect the VC470 to the power supply.
2. Now switch on the power supply.
3. The VC470 goes into programming mode for 3 minutes.
a) Programming master transmitter
When the receiver is in programming mode, press the programming button on
the transmitter and hold for 3 seconds.
The curtain will make a slight movement to confirm programming, i.e. the cur-
tain will move a few centimetres.
This confirmation is referred to as "nodding" in the rest of the operating instruc-
tions.
When the curtain "nods", this signifies that the programming process has been
successfully completed.
Note
If a transmitter has already been programmed in the receiver, press the
programming button and hold for 10 seconds.
b) Programming additional transmitters
Note
In addition to the master transmitter, up to 15 further transmitters can
be programmed in the VC470.
1. Press the programming button of the master transmitter programmed in point
a) for 3 seconds.
The curtain will "nod" to confirm.
2. Now press the programming button of a new transmitter which has not yet
been programmed in the VC470 and hold for 3 seconds. Doing so activates
the programming mode of the VC470 for a new transmitter for 3 minutes.
The curtain will "nod" to confirm.
3. Now press the programming button of the new transmitter which you wish to
programme for a further 3 seconds.
The curtain will "nod" to confirm.
The new transmitter has been successfully programmed in the receiver.
22
Advertenties
Inhoudsopgave
