Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
bucket edge.
The wiper should be removed for mixing of coarse-grained materials
(e.g. screed).
IMPORTANT!
The use of chemical products or solvents can impair the
!
properties of the mixing bucket and the machine.
Before using the TwinMix 1800, check that the products to
be mixed are compatible with the properties of the machine.
Removing the Mixing Bucket
Turn the machine off and wait until the stirrers have stopped.
Move the complete mixing unit out of the button, until the slide locks at
the end position.
Move the bucket car out of the mixing station.
CAUTION!
Do not lift full mixing buckets alone from the bucket car!
Tool Protection
Wrong handling can cause damages on the tool.
Therefore, please always observe the following instructions:
Do not stress the tool to such an extend that it stops by itself.
Electronic:
In case of overload due to too large feed force, the
electronic will cut OFF the machine. After discharge and
switching ON you can continue drilling again.
Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
When inserting the tool, you could catch your hands. For this reason,
always wear protective gloves for changing the tool.
For tool change, you can tilt the TwinMix 1800 T to the rear and can rest it
on the handles (3).
Universal stirrer (A):
For change of the stirrer (9), the two fixing bolts must be loosened from the
mixing paddle (10).
Use a spanner SW 22 to loosen the stirrer (9) and to lock the work spindle.
18
Advertenties
Inhoudsopgave
