Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
30
English
Problem
The milk does not froth. The classic pannarello may be
The "INTENZA+" filter
cannot be inserted.
You can not activate the
"INTENZA+" filter.
There is some water
under the machine.
The machine is in
DEMO mode.
4219-465-02411 MAN. GAG. MAGENTA Plus EN-NL-PL Rev 03.indd 30
Cause
dirty.
(model with classic pannarello)
The steam wand nozzle is clogged.
(model with steam wand)
The type of milk used is not
suitable for foaming.
Remove the air from the filter.
The tank still contains some water.
The rubber seal is not inserted onto
the "INTENZA+" filter.
Another filter is already active
The drip tray is too full and has
spilled over.
While switching on the machine,
you pressed a combination of
buttons (HOME
- CLEAN/SET
– HOME
- CLEAN/SET
).
Solution
Clean the classic pannarello as described in
the chapter "Cleaning the classic pannarello".
Make sure that all the classic pannarello
components have been correctly assembled
Wash the steam nozzle with running water and
clean the circuit by dispensing a small quantity
of hot water
The amount and the quality of froth vary
depending on the type of milk.
Let the air bubbles out of the filter.
Empty the water tank before installing the filter.
Check the packaging and insert the seal onto
the "INTENZA+" filter.
The machine indicates the filter usage in
percentage.
However, if you want to activate a new filter
before the one currently in use has expired, the
latter must be disabled first as described in the
section "Replacing INTENZA+ water filter"
Empty the drip tray when the mark appears
though the tray. Always empty the drip tray
before starting the descaling procedure.
Switch the machine off and on again, with the
button on the control panel.
ON/OFF
19/04/2021 15:26:50
Advertenties
Hoofdstukken
Inhoudsopgave
