Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
10
English
4219-465-02411 MAN. GAG. MAGENTA Plus EN-NL-PL Rev 03.indd 10
Installing the INTENZA+ water filter
Immerse the INTENZA+ water filter in cold water, in a vertical position and with the
opening facing upwards. Press both sides of the filter gently to let air bubbles out.
Remove the INTENZA+ water filter from the water. Set the machine according to
the detected water hardness - see the "Measuring water hardness" chapter. On the
filter base, please set one of the following:
A = soft water – 1 or 2 small squares
B = hard water (standard) – 3 small squares
C = very hard water – 4 small squares
Place the INTENZA+ filter in the water tank, ensuring it is correctly positioned. Refill
the water tank and place it back in its housing.
1
Press the CLEAN/SET
2
Select " WATER FILTER " and press the "
Select " ACTIVATE " and follow the instructions on the display to activate the
3
filter correctly.
Note: you can pause the filter activation procedure by pressing the START/STOP
button. To resume the filter activation procedure, press the START/STOP
button again.
Replacing the INTENZA+ water filter
When the INTENZA+ water filter expires, the warning message appears on the
display.
Replacement or deactivation can be executed by pressing the CLEAN/SET
1
button and then the " SETTINGS " button.
Select " WATER FILTER" then press the "
2
Select "REPLACE " to change the filter or " DISABLE "if you do not intend to use
3
the filter. Confirm with the "
Follow the instructions shown on the display to activate the filter.
button and then the " SETTINGS " button.
" button.
" button.
" button.
19/04/2021 15:26:08
Advertenties
Hoofdstukken
Inhoudsopgave
