Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Headrest
Headrest (Fig. 6.30)
You can adjust the height of the
headrest and it can be moved
forwards and backwards,
horizontally. To do this, loosen the
screw (1 or 2). This is how you
can adjust to the required
positions. Re-tighten the screws
(see the page on torque).
Stabilizing Bar
Folding stabilising bar
This bar is used to stabilize the
backrest.
To be able to fold the wheelchair,
the release lever must be pushed
inwards (Fig. 6.31) or released
and the stabilising must be flipped
downwards. When unfolding the
wheelchair, please make sure that
the stabilising bar is locked into
position.
Options – One Hand Operation
One Hand Operation
(Fig. 6.32 - 6.32.1)
To propel the chair straight
forward both handrims
must be used. To fold the
wheelchair disconnect the
telescopic bar by pushing it
inward (1). To take off the
wheels, press the locking
button on the axle (2).
CAUTION!
Make always sure that the
connections are set
properly to avoid injuries.
Fig. 6.32.1
Life i
Rev.I
Fig. 6.30
Fig. 6.31
Fig. 6.32
Fig. 6.31
Fig. 6.33
Fig. 6.32
2
1
Sideguards
Central support
Installation: Slide the arm post into the receiver, located on the
1
wheelchair frame, until it stops
Height adjustment:
Slide the arm rest post out of the receiver.
Adjust the position of the hight adjustment bracket (1) by
removing the screw (2) and moving it to the desired posiion.
2
Re-fit the screw and tighten it.
Slide the arm rest post back into the receiver, (Fig. 6.33).
Armpad Position:
The armpad position can be adjusted by relesing the screws
(3), then moving the arm pad to the desired position. Re-tighten
the screws, (Fig. 6.33).
Adjusting Armrest Receiver
The tightness of the armrest receiver can be adjusted (tightened
/loosened) by means of the 2 screws (1) - (Fig. 6.34).
Sideguard With Clothes Protector (Fig. 6.35)
The clothes protector prevents clothes getting dirty from spray
water. You can set the position in relation to the rear wheel by
moving the sideguard.
To do this, remove the fixing screws (1 and 2).
After setting to the desired position, re-tighten the screws (see
the page on torque).
WARNING!
Neither the sideguards nor the armrests are to be used for
lifting or carrying the wheelchair
Fig. 6.33
Fig. 6.34
3
1
Fig. 6.35
Fig. 6.36
1
Fig. 6.34
Fig. 6.35
2
1
2
23
Advertenties
Hoofdstukken
Inhoudsopgave
