Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
- While in heating mode, press the SLEEP key to set the temperature. It decreases 1 ℃ after
an hour and at most decreases 2 ℃ after 2 hours.
- Press the SLEEP key again can cancel the setting.
6.9 Water drainage
Water Full Alarm
The inner water tray in the air-conditioner has one water level safety switches, it
controls the water level. When water level reaches an anticipated height, the water
full indicator lights up. When the water is full, please remove the rubber blockage
from the drainage outlet at the bottom of unit, and drain all water outside.
Continuous Drainage
When you plan to leave this unit unused for a long time, please remove the rubber
-
blockage from the drainage hole at the bottom of unit, and drain all water outside.
You can use the continuous drainage with a drainage hose connected to the bottom
-
drain hole, when the unit working at the HEAT mode.
The continuous drainage is not need to be applied when the unit working at the
-
COOL or DEHUMIDIFY mode. The unit can evaporate the condensate water
automatically by the splash motor. Make sure the drainage holes are stemmed well.
If water splash motor is damaged, continuous drainage can be used. To connect the
-
drain hose to the bottom drainage outlet (Fig.6), the unit can also work well.
If splash motor is damaged, intermittent drainage can also be used. Under this
-
condition, when the water full indicator lights up, please connect a drain hose to the
bottom drainage hole, then all the water in the water tank will be drained outside.
The unit can also work well.
6.10 WIFI function
- Long press the SPEED button for 5s, enter the WIFI factory set up mode;
- The unit is connected with WIFI If the WIFI indicator is on, other wise is not
connected. When the WIFI indicator flashing slowly, the unit is at the WIFI set up mode,
if flashing quickly, the unit is connected with WIFI;
- You can realize all the air conditioner functions by the mobile phone APP with the
WIFI connected.
7. Installation Explanations
7. Installation Explanations
7.1 Installation Explanations:
A removal air-conditioner shall be installed in the flat and empty place all around.
-
Don't block the air outlet, and the required distance around should be at least 30cm.
(See
Fig.8)
Should not be installed in wet location, such as the laundry room.
-
Socket wiring should be in accordance with the local electric safety requirements.
-
Advertenties
Hoofdstukken
Inhoudsopgave
