Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3. Fill the salt reservoir with water.
Note:
You only have to fill the salt reservoir with water before first use of the appliance.
4. Put a funnel in the opening of the salt reservoir.
5. Fill the reservoir with salt until the overflow level.
6. Install the cap of the salt reservoir.
Caution:
Remove any spilled salt immediately and run a full program to prevent corrosion of the appliance.
SETTING THE LEVEL OF SALT CONSUMPTION
The salt consumption of the appliance depends on the level of water hardness.
Set the level of salt consumption according to the information in section
consumption)'
.
Note:
Contact your local water company to verify the level of water hardness in your area.
Note:
As a default, the level of water hardness of the appliance is set to level H3.
1. Push the on/off button to start the appliance.
2. Push and hold the program selector button Quick '30 within 1 minute after the appliance starts.
3. Push the program selector button Quick '30 again to change the level of water hardness.
4. Push the on/off button to confirm the setting.
FILLING THE DETERGENT RESERVOIR
Warning:
Store detergent out of reach of children in a cool and dry place.
Caution:
Only use detergent that is suitable for dishwashers.
Caution:
Do not put a detergent tablet in the cutlery basket, only use the detergent reservoir.
Note:
Detergent is available in powder, gel and tablets and is also available as a combined product (with salt
and/or rinse aid). Combined products only produce sufficient results under certain conditions. Observe
the instructions of the packaging.
1. Make sure that you fill the detergent reservoir before you start the appliance.
2. Push the latch (A) to open the detergent reservoir.
38
•
English
'Water hardness level settings (salt
(Figure 4)
(Figure 5)
(Figure 6)
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
