Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
16. Eliminating faults
Even though this remote control system has been constructed according to the current state of the art, there may still
be faults or problems. For this reason, we would like to show you how to eliminate any faults that may occur.
Problem
The transmitter does not respond
The servos don't respond
The servos are trembling
A servo is buzzing
The system only has a low range
The transmitter switches itself off
immediately or after a short time
60
Remedy
• Check the batteries/battery packs of the transmitter.
• Check the function switch.
• Check the batteries or battery pack of the receiver.
• Test the switching cable.
• Check the BEC function of the drive regulator.
• Check the poling of the servo plug.
• Carry out the binding function.
• Check the batteries/battery packs of the transmitter and receiver.
• Dry any damp in the receiver carefully with a hot air blower.
• Check the batteries or battery pack of the receiver.
• Check the easy of movement of the steering rods.
• Operate the servo without the servo lever for test purposes.
• Check the batteries/battery packs of the transmitter and receiver.
• Check the receiver antenna for damages.
• Position the receiving antenna in the model differently for test purposes.
• Check the batteries/battery pack of the transmitter and replace if
necessary.
Advertenties
Hoofdstukken
Inhoudsopgave
