Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
9. Basic operation
a) Installation
• Place the product with the back on a level, smooth surface. Try not to move it during a test.
b) Switching on/off
• Press and hold the EXIT
LC display (4) lights up. A signal is emitted to confirm that the device has been switched on.
• Press and hold the EXIT
LC display (4) goes out. A signal is emitted to confirm that the device has been switched off.
c) Automatic shut-off
The cable tester switches off automatically after a certain time with no operation to save power.
A shut-off period of 10 minutes without input is pre-set. You can change this shut-off time
according to your preferences. Refer to the Chapter '14. Device settings', Section 'Setting the
time for automatic shut-off "Auto OFF time"' for information on how to implement the setting.
d) Selecting the function menu and functions
After switching on the device, the device is automatically set to measure the length of data
cables.
26
button (9) for approx. 3 seconds to switch on the cable tester. The
button (9) for approx. 3 seconds to switch off the cable tester. The
• Briefly press the EXIT
measuring menu to the function menu. The function menu appears.
The following functions are available:
- 'Cable Test': check/measure cable lengths
- 'Velocity of propagation': determine speed factor
- 'History': storage of measured values and data until the next
shut-off.
- 'Setting': change settings on the device
• Press the
(1) or
• Press the TEST OK button (3) to confirm a function.
All functions are described in detail in the following chapters.
button (9) to switch from the data cable
(8) buttons to select a function.
Advertenties
Hoofdstukken
Inhoudsopgave
