Advertenties
Beschikbare talen
Beschikbare talen
6.3 Cleaning and soot removal
Soot deposits may build up on the internal surfaces of the
fi replace during use. Soot is a good insulator and will therefore
reduce the fi replace's heat output. If soot deposits accumulate
when using the product, they can easily be removed by using
a soot remover.
An annual internal cleaning is necessary to get the best heating
eff ect from your product. It is a good idea to do this when
cleaning the chimney and fl ue pipes.
6.4 Sweeping fl ue pipes to the
chimney
Flue pipes must be swept through the fl ue pipe sweeping hatch
or through the door opening.
6.5 Inspection of the fi replace
Jøtul recommends that you carefully inspect your fi replace
yourself after it has been swept/cleaned. Check all visible
surfaces for cracks. Also check that all joints are sealed and
that the gaskets are in the correct position. Any gaskets showing
signs of wear or deformation must be replaced.
Thoroughly clean the gasket grooves, apply ceramic glue
(available from your local Jøtul dealer) and press the gasket
well into place. The joint will dry quickly.
6.6 Exterior maintenance
Painted products may change colour after several years' usage.
The surface should be cleaned and brushed free of any loose
particles before new paint is applied.
7.0 Servicing
Warning! Any unauthorised changes to the product are
illegal!
Only original spare parts may be used!
7.1 Replacing the burn plates,
baffl e and exhaust defl ector
Fig. 44
B
1
1. First remove the log retainer (Fig. 13 A) .
2. Remove the side burn plate (A) by lifting it up slightly while
holding the baffl e (B) up. Pull the side burn plate out at the
bottom and lift it out.
3. Then lift out the other side burn plate while holding the baffl e
up in the same way as for the fi rst side burn plate.
Fig. 45
A
1
4. First lift the baffl e (A) up. Turn the key (B) 90° and then
remove the key. Pull the back edge of the baffl e down.
ENGLISH
2
A
B
2
31
Advertenties
Hoofdstukken
Probleemoplossen
