Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
Placing an insert inside an open
fi replace
Fig. 30
1. Cut along the knock-out holes at the top of the heat shield
and remove that section.
Fig. 31
Fig. 32
2. Before inserting the burn chamber inside the fi replace,
remove the log retainer, side burn plates, back burn plate,
baffl e and exhaust defl ector. These are fi tted back into place
when the fl ue pipe and smoke bell have been installed. See
the fi gures below.
26
Fig. 33
3. Slide the burn chamber in on the moulded runners on
the bottom until it is in place. Level the burn chamber as
described in "Levelling the insert".
Fig. 34
A
4. Fit the gasket (A) onto the edge of the fl ue pipe.
Advertenties
Hoofdstukken
Probleemoplossen
