Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Scan sensitivity setting – FM
Your radio includes a local/distant option for the auto-scan function. By setting the radio to the "local"
scan option, weaker signals from more distant transmitters can be ignored by the radio, making
stronger signals easier to find.
1. Press the Power On/Off button to switch on your radio.
2. If needed, press and release the Source button until the FM band is selected.
3. Press and hold the Info/Menu button to access FM menu. Rotate the Tuning control knob until "FM
Scan Zone" shows on the display. Press and release the Tuning control knob to enter the scan
sensitivity adjustment mode. The current setting will be marked with an asterisk.
4. Rotate the Tuning control knob to switch between "Local" (Strong stations only) and "Distant" (All
stations) options on the lower line of the display. The Distant option will allow the radio to find
weaker signals when scanning.
5. Press and release the Tuning control knob to confirm your selection. The setting is stored in the
radio and remains in force until changed or until a System Reset.
Preset stations in DAB and FM modes
There are 5 memory presets for each DAB/FM wavebands.
1. Press the Power On/Off button to switch on your radio.
2. Tune to the required station as previously described.
3. Press and hold the required Preset button until the display shows e.g. "Preset 2 stored". The station
will be stored under the chosen Preset button. The corresponding preset number e.g."P2" will show
on the display. Repeat this procedure for the remaining presets.
4. Station stored in the memories may be over written by following the above procedure.
Recall a preset in DAB and FM modes
1. Press the Power On/Off button to turn on the radio.
2. Press the Source button to select the required waveband.
3. Momentarily press the required Preset button, the preset number and station will appear in the
display.
Note: The display will show "Preset Empty" if no station has been stored to that preset.
Listening music via Bluetooth streaming
You need to pair your Bluetooth device with your radio before you can auto-link to play stream
Bluetooth music through your radio. Pairing creates a "bond" so two devices can recognize each other.
Pairing and playing your Bluetooth device for the first time
1. Press the Source button to select Bluetooth function. The "Bluetooth Pairing" will show on the
display.
2. Activate Bluetooth on your device according to the device's user manual to link to the radio. Locate
the Bluetooth device list and select the device named "DABPRO 2" (With some Smartphone's that are
equipped with earlier versions than BT2.1 Bluetooth device, you may need to input the pass code "0000").
12
Advertenties
Inhoudsopgave
