Advertenties
Beschikbare talen
Beschikbare talen
Installation of the LS10 light sensor
1.
Mount the light sensor to the outer wall or to the roof.
2.
Select a point at which the amount of sunshine can be
perfectly measured, and where objects such as trees,
roofs, etc. will not affect the light measurement. The sen-
sor must not be shaded by the extended awning!
3.
Remove the upper section of the housing.
4.
Connect the cable to the terminals (any polarity), and fix
the cable with the strain relief. Connect the cable to the
SWA with terminals 15 and 16 or 17 and 18 (in the case
of a 2nd sensor).
5.
Secure the underneath of the housing with the metal
angle provided. The cable guide will point downwards.
Note
Please note that if the light sensor is exposed
to external lighting installations (including at
night), this can cause extension of the awning.
E
Installation of the AN2 wind speed sensor
N
1.
Fix the AN2 wind speed sensor vertically on the outside
wall or on the roof with the help of the mounting bracket.
G
2.
Screw the wind speed sensor tightly to the mounting
L
bracket.
I
3.
Connect the wind speed sensor to the "+" and "2" termi-
nals of the control (any polarity).
S
Note
H
The installation location must be selected so
that even when the awning is extended the
wind sensor can measure the present wind
speed and thus protect the awning against ex-
cessively high wind speeds. Avoid mounting
the wind sensor beneath roof overhangs or in
the vicinity of other objects (extended awning,
trees, building) that may affect the measure-
ment.
18
Operating Instructions SWA 50II
4
5
Advertenties
Hoofdstukken
