Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
9.4 Glass panes
•
!Caution
•
Use the supplied glass pane cleaner to remove fingerprints from the glass pane(s).
!Tip
9.4.1 Disassembly of glass panes
9.4.1.1 Disassembly of glass pane in door
To remove the glass pane in the door, please follow the instructions below (see Annex 2, fig. 11):
Ø
Open the door.
Ø
Lift out the door by sliding it upwards.
Ø
Place the door on a flat surface.
Ø
Remove the door seal.
Ø
Unscrew the nuts under the door seal from the glass strip.
Ø
Remove the glass strips.
Ø
Lift the glass pane out. The pane seal is also taken out.
When replacing the glass pane always replace the glass pane seal in the door (= seal between the glass pane and
!Tip
the door) AND the door seal (= seal between the door and the fire).
9.4.1.2 Disassembly of side panes
The side panes must be replaced in case of cracks or fractures in the glass pane.
Ø
Unscrew the Allen screw (see Annex 2, fig. 12).
Ø
Now follow the steps described in paragraph 9.4.1.1 'Disassembly of glass pane in door'.
The side panes are made of IR glass. This glass consists of a coating that reflects a large part of the infra red
!Caution
radiation (heat radiation). This glass is characterized by a rough and smooth side (coating). It is very important that
the side panes are mounted with the coated side towards the outside.
Mark the coated side of the side panes before disassembling the side pane. This will help you to place back the
!Tip
side panes correctly.
9.4.2 Assembly of glass panes
9.4.2.1 Assembly of glass pane in door
Assemble the glass pane in the door according to the steps described in paragraph 9.4.1.1 'Disassembly of glass
pane in door', only in reverse order.
•
!Caution
•
•
•
Make sure that the sleeve is placed on the underside of the glass pane.
!Caution
9.4.2.2 Assembly of side panes
For assembly of the side panes, please observe the instructions provided in paragraph 9.4.1.2 'Disassembly of side
panes', only in reverse order.
Properly press down the side doors during assembly, before the Allen screws are tightened again! The side doors
!Caution
must fit onto the appliance properly, in order to prevent leakage and attraction of false air.
Mount the panes with the rough side towards the outside (see 9.4.1.2).
!Caution
42
Avoid damage when removing/fitting the glass pane.
Avoid/remove fingerprints on the glass pane(s) as they will burn into the glass.
Do not fasten the bolts too tight to avoid breaking off and/or stripping: overtightening will cause breakage.
Place the glass pane (including new pane seal) with the logo to the bottom right.
Place a new door seal.
Slide both ends of the door seal in the supplied sleeve (see Annex 2, fig. 11).
I N S T A L LA T I ON M A N U A L
Advertenties
Hoofdstukken
Inhoudsopgave
