Moederbord; Removing The System Board - Dell OptiPlex 3000 Thin Client Servicehandleiding
Verberg thumbnails
Zie ook voor OptiPlex 3000 Thin Client:
- Installatiegids (11 pagina's) ,
- Servicehandleiding (74 pagina's)
Inhoudsopgave
Advertenties
Steps
1. Remove the fillers on the side cover.
2. Route the white antenna-cable through cable clip and the routing guides on the system.
3. Tilt the internal antenna assembly. Align and insert the antenna bracket into the opening on the system board.
4. Rotate the antenna bracket to align the SMA antenna assembly with the screw hole on the back view.
5. Replace the screw (M3x3) to secure the SMA antenna assembly to the system.
Next steps
1. Install the
WLAN
card.
2. Install the
side
cover.
3. Follow the procedure in
Moederbord
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
speaker
.
4. Remove the
solid-state drive
5. Remove the
memory
.
6. Remove the
WLAN
card.
7. Remove the
heat
sink.
About this task
The following image indicates the connectors on your system board.
38
Onderdelen verwijderen en plaatsen
after working inside your
before working inside your
assembly.
computer.
computer.
Advertenties
Inhoudsopgave
