Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
obstacles. Ensure that no people, animals or flammable objects are located directly under the
radiator!
Wall and ceiling fastening:
Set the desired radiator angle: the radiator can rotate 2 x 30°. To do this, unscrew the locking
nut (8) and the bolt (10) a little, and then screw them tight again after adjusting the angle. Do
not point the wall-mounted TH1800R upwards! This makes no sense and can damage the
ceiling!
Fasten all screws another time firmly and scheck or the heater is firmly mounted. Now your
infra red heater is ready for use.
For personal protection the installation, to which the EUROM TH1800R is connected, has to
be equipped with an earth fall device (max. 30 mAmp).
Under some circumstances it may be attractive to make a fast connection between the heater
and the main supply, and to operate the heater with a switch. Because the EUROM TH1800R
has a high water tightness (IP65) and for safety reasons, such a connection has to be made by
a qualified electrician.
The remote control for the patio heater works on 2 batteries (1.5V DC LR03/RO3/AAA). The
battery compartment in the remote control is located at the back.
Slide it open, install the batteries (+ to +, - to -) and close the lid.
Point the remote control towards the sensor on the patio heater
during use. If there are obstacles between the remote control and
the sensor, it won't work!
Only use non-rechargeable batteries. Remove the batteries if the
heater is not to be used for a while as this will extend the lifespan
of the remote control. Replace empty or leaking batteries and
dispose of them with chemical waste. The chemical substances
in batteries should not come into contact with the skin or eyes or
be swallowed. If this happens, consult a doctor immediately.
WORKING
Check for every use:
- or the appliance doesn't show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o wind
or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (230V-50Hz).
If everything is all right you can insert the plug into the socket. Press the ON/OFF switch to ON
(I depressed) – the blue light on the control panel will start to flash. Use the 'ON/OFF' button on
the control panel of the 'ON' button on the remote control to activate the radiator.
Press the 'ON/OFF' button again or the 'OFF' button on the remote control to switch it off again.
Now change the ON/OFF switch of OFF (O protruding) and take the plug out of the wall socket.
Allow the radiator to cool down.
When you use the appliance for the first time (or after a long time again), observe it during the
first 10 till 15 minutes to be sure that is works trouble-free. When you have been using the
device for some time the colour of the glass surface of the heating element may change to white
in patches. This is normal and does not have any effect on the performance or life span.
16
Advertenties
Inhoudsopgave
