Advertenties
Beschikbare talen
Beschikbare talen
3. The battery
21
22
66
Besides these safety instructions, there are some specific
instructions for charging the battery in the bike and
separately from the bike.
Instructions for connecting the battery in the bike
•
Follow the safety instructions given earlier.
•
Park the bike on its stand in the vicinity of a mains socket.
•
Open the rubber cover cap of the battery charging socket
(to the left of the rear light) and insert the plug from the
charger (ill. 21).
•
Ensure that the plug is firmly seated in the battery (ill. 22)
and connect the charger to the mains socket.
•
The LED in the rear light flashes when you connect the
charger correctly. On the charger itself a green light will
be on, indicating that the charger is in use.
Instructions for connecting the battery separately
from the bike
•
Follow the safety instructions given earlier.
•
Remove the battery from the bike according to the
instructions given earlier (3.3).
•
Place the battery on a flat and hard surface in the
vicinity of a mains socket.
•
Open the rubber cover cap of the battery loading plug,
on the left near the rear light, and plug in the charger
(ill. 21).
•
Make sure the plug is attached firmly to the battery
(ill. 22) and plug it into the mains socket.
•
The LED in the rear light flashes when you connect the
charger correctly. On the charger itself a green light will
be on, indicating that the charger is in use.
General loading instructions
•
The flashing LED displays the battery's level of charge.
The LEDs start on the far right and move to the left.
Each LED indicates approximately 20% of a full charge.
•
When the battery is fully charged, there will be no LEDs
lit on your rear light. The green lamp will still be lit on
the charger (ill. 23).
Advertenties
