Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Getting to know your appliance
The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.
The control panel
Displays
Heat settings
‚
-
Š
Residual heat
/
•
œ
Controls
Main switch
#
Childproof lock
@
Hotplate selection
$
Adjustment fields
A @
Notes
When you touch a symbol, the respective function is
■
activated.
Setting the hob
This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: Touch the
#
The indicator light above the main switch and the
light up. The hob is ready for use.
To switch off: Touch the
#
the main switch and the displays go out. All hotplates are
switched off. The residual heat indicator remains on until the
hotplates have cooled down sufficiently.
Notes
The hob switches off automatically if all hotplates have been
■
switched off for more than 20 seconds.
The settings remain stored for 4 seconds after the hob has
■
been switched off. If you switch it on again during this time,
the hob will operate using the previously stored settings.
Setting a hotplate
Use the + and - symbols to set the desired heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.
18
symbol. An audible signal sounds.
displays
‹
symbol until the display light above
Always keep the controls dry. Moisture reduces their
■
effectiveness.
Do not pull pans close to the displays and sensors. The
■
electronics could overheat.
Residual heat indicator
The hob has a two-stage residual heat indicator for each
hotplate.
If
•
appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to
œ
. The display remains lit until the hotplate has
cooled sufficiently.
Setting the heat setting
The hob must be switched on.
Touch the
$
symbol to select the hotplate.
1.
Touch the + or - symbol within the next 10 seconds. The
2.
basic setting appears.
Symbol + heat setting 9
Symbol - heat setting 4
To change the heat setting: touch the + or - symbol until the
3.
desired heat setting appears.
Switching off the hotplate
Use the
$
symbol to select the hotplate. Touch the + or -
symbol until
‹
appears. After about 10 seconds, the residual
heat indicator appears.
Advertenties
Hoofdstukken
Inhoudsopgave
