Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Positioning the logs
• Position the plates F(806429) and G(806430) with the
smooth side up, as shown in figs. 19A, 19B and detail 19C.
Ensure the plates join at the points indicated by the
arrows.There will be a gap around the burner, this is
normal. Be careful, the plates are breakable!
• Fill the burner trays with vermiculite (H) and distribute
evenly, (see fig. 20).
(The vermiculite is in a plastic bag packed with the logs).
• Position logs 1 and 2 as shown in fig. 21B. Make sure log 1
is laid against the notches (Y) so that the distance X is
more or less the same both left and right. Lay log 2 on the
log support (Z) on the air duct divider (C).
• Position log 3 as shown in fig. 21E.
The notch of log 3 should fit into the hole of log 2, see fig.
21C. Be careful not to break the notch off!
At the front, log 3 is positioned on to the notch of log 1,
see fig. 21D.
• Now position logs 4 and 5 as shown in fig. 21F. Position
logs 4 and 5 so that they practically lie against log 1, as
shown by the arrows.
• Distribute the black chippings (I) on the grid so that they
overlap. Chippings may also be spread on the front burner,
see fig. 22A. (The chippings are in a plastic bag packed with
the logs). If you find any large lumps of chippings in the
bag, please break them into smaller pieces.This will benefit
the flame effect.
G
INSTRUCTIONS FOR INSTALLATION
• You can then lay a few chippings on the other burners to
create a glowing-embers effect, see fig. 22B. Be careful not
to place any chippings near the cross-lighting sections of
the burners.These are where the burners are ignited by
the "cross-lighting burner". (The back burners must not be
completely covered with chippings. A few chippings are
allowed).
• Finally, spread some chippings round the logs on plates F
and G, as shown in fig. 22B.
fig. 19A
33
F
Apollo
Advertenties
Hoofdstukken
Inhoudsopgave
