Advertenties
Beschikbare talen
Beschikbare talen
G Operating instruction
Controls and Displays
1.
AM/PM (12-hour format)
2.
Time
3.
Day
4.
Month
5.
Day of the week
6.
Moon phase
7.
Room temperature
8.
Time zone
9.
Summer time
10.
Battery symbol
11.
Wireless symbol
12.
Opening for wall mounting
13.
Base
14.
MODE button
= settings/con rms the setting
°F/°C button
15.
= switches between °C and °F
16.
UP button
= increases the current setting; activates/deactivates manual radio signal reception;
switches the display mode
17.
DOWN button
= decreases the current setting; activates/deactivates manual radio signal reception;
selects the language
18.
Battery compartment
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep
these instructions in a safe place for future reference. If you sell the device, please pass
these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your attention to speci c
hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
2. Package Contents
• DCF wireless wall clock
• 1 AA battery
• These operating instructions
3. Safety Instructions
• The product is intended for private, non-commercial use only.
• Use the product for its intended purpose only.
• Protect the product from dirt, moisture and overheating, and only use it in a dry
environment.
• Do not operate the product outside the power limits given in the speci cations.
• Do not use the product in moist environments and avoid splashes.
• Do not use the product in the immediate vicinity of heaters or other heat sources or in
direct sunlight.
• Do not use the product in areas where the use of electronic devices is not permitted.
• Do not place the product near interference elds, metal frames, computers, TVs, etc.
Electronic devices and window frames can negatively affect the product's functionality.
• Do not drop the product and do not expose it to any major shocksl.
• Do not open the device or continue to operate it if it becomes damaged.
• Do not attempt to service or repair the product yourself. Leave any and all service work
to quali ed experts.
• Keep the packaging material out of the reach of children due to the risk of suffocation.
• Dispose of packaging material immediately according to locally applicable regulations.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep this product, as all electrical products, out of the reach of children!
• Use the item only in moderate climatic conditions.
Warning – Batteries
• When inserting batteries, note the correct polarity (+ and - markings) and insert
the batteries accordingly. Failure to do so could result in the batteries leaking or
exploding.
• Only use batteries that match the speci ed type. Keep the instructions for the correct
choice of batteries included with the operating instructions of devices safe for future
reference.
• Before you insert the batteries, clean the battery contacts and the polarity contacts.
• Do not allow children to change batteries without supervision.
• Replace all the batteries in a set at the same time.
Warning – Batteries
• Do not mix old and new batteries, or batteries of different types or from different
manufacturers.
• Remove the batteries from products that are not being used for an extended period
(unless these are being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow them to enter the environment.
They can contain toxic, environmentally harmful heavy metals.
• Remove spent batteries from the product and dispose of them without delay.
• Avoid storing, charging and using in extreme temperatures and at extremely low
atmospheric pressures (such as at high altitudes).
• Ensure that batteries with damaged housings do not come into contact
with water.
• Keep batteries out of the reach of children.
4. Getting Started
4.1 Inserting the battery
Remove the battery that was already inserted into the clock, remove the protective lm if
necessary as well as the contact interrupter and the re-insert the battery with the correct
polarity. The clock is ready for operation.
4.2 Replacing the battery
Remove and dispose of any used batteries. Insert the new battery (AA). Ensure that the polarity
of the battery corresponds to the symbols in the battery compartment (18).
5. Installation
Warning – Mounting Note
• Before mounting the clock, ensure that the chosen wall is suitable for
the weight to be mounted, and make sure that there are no electrical
wires, water, gas or other lines at the installation site on the wall.
• Purchase special fastening materials from specialised dealers.
• Do not mount the product above locations where persons might linger.
• You can mount the wall clock on a wall using the opening on the back (12).
• You can also stand the wall clock on a level surface using the base (13).
6. Operation
Note – Input
Hold down the UP button (16) or the DOWN button (17) to select the
values faster.
6.1. Automatic setting using the DCF signal
• Once the batteries are inserted, the clock automatically searches for a DCF signal. During
the search, the wireless icon (11) ashes.
Display
Display ashing
Displayed continuously
Not displayed
• If the station still does not receive a signal, press and hold the UP button (16) and the
DOWN button (17) for approx. 3 seconds to start the manual search for the DCF signal.
The wireless icon (11) will start to ash.
Note – Time settings
• The search process takes about 3-10 minutes. If the search fails, it ends
and is repeated at the next clock hour. The wireless icon (11) disappears.
• In the meantime you can, however, set the time and the date manually.
• The clock automatically continues to search for the DCF signal on a daily
basis (between 1:00 a.m. and 5:00 a.m.). If the signal is received successfully, the
manually-set time and date are overwritten.
Summer time
Note –
The clock automatically switches to summer time. S (9) appears on the
display as long as summer time is activated.
Searching for the DCF signal
Active
Successful – signal is being received
Deactivated
3
Advertenties
