Inhoudsopgave
Advertenties
4.3 Aligning the camera module
Loosen one of the two screws to the left or right of
the camera module (see diagram on right, item 7).
Use the tool provided to do this (hexagon wrench).
You can now align the spherical camera module
vertically and (slightly) horizontally by inserting the
tool in the opening on the top of the camera module
(see diagram on right, item 8).
Retighten the fixing screw.
4.4 Description of the status LEDs
LED
P – LED for displaying the
operating voltage
S & L – Network status
S & L – Network status
4.5 Description of the reset button function
Function
To reset the camera to factory settings, press the
reset button on the camera. Then disconnect the
power supply to the camera but still hold the reset
button.
Now reconnect the power supply.
After 10 seconds release the reset button.
Now the camera is reseted to factory defaults.
State
Constantly red
S lights up orange, L flashes green
(at irregular intervals)
Both LEDs inactive
Description
Camera reset to the factory settings.
40
5
7
6
8
Description
Power supply active
Network status is OK, IP assigned
correctly
Disconnected from network
7
Advertenties
Hoofdstukken
Inhoudsopgave
