Inhoudsopgave
Advertenties
Water outlet
During cooling and dehumidification, the device extracts water from the air. This
largely evaporates again, but possibly. excess water accumulates in the water
reservoirs. When full, the
compressor and motor
stop automatically and
the "water tank full"
(W.F) light turns on. In
that case, switch off the
air conditioning and
remove the plug from
the socket. You empty
the water reservoirs by
removing both sealing
caps from the top and
bottom water drainage
point (see pictures) and
draining the reservoirs
into a drain or collecting
them in a container or
similar. Do not forget to
replace the sealing caps
on the drain afterwards! After this you can start using the air conditioning again.
Safety
The Cool-Eco is fitted with an overheating safeguard that switches the unit off if it
overheats. If this should occur, you must remove the plug from the socket and
leave the equipment to cool for at least 30 minutes. Remove the cause of
overheating - has the device been (partially) covered? Is it too close to a wall or
another obstacle, preventing it sucking in or dispelling sufficient air?
You can then use the device normally again but keep an eye on it for the first 30
minutes to ensure there are no further problems. If the device is showing signs of
problems or the overheating recurs, even though there is no obvious assignable
cause, ask your supplier or a recognised electrician to check/repair the unit.
Cleaning and maintenance
Note! Before cleaning or carrying out maintenance work on the air conditioning
unit, always switch off and remove the plug from the socket! Regular cleaning is
vital in order to keep the unit in good working order!
51
Advertenties
Inhoudsopgave
