Inhoudsopgave
Advertenties
10. Installation
Proceed as follows when installing the camera.
1.
Select a suitable place to mount the camera.
Without a protective housing, this camera must only be used in VdS-regulated conditions
out of arm's reach (min. 3m installation height).
2.
Connect the video cable (recommended cable type: RG59) with the BNC video output of
the camera and the device directly connected to the camera. The maximum cable length
must not exceed 200 m.
3.
Connect a power supply to the camera.
4.
Hold the camera at the location where you want to mount it. Check the orientation and
angle of the camera.
5.
Select the required settings in the camera's programming menu.
6.
Set the required zoom range.
7.
Fasten the camera. Make sure that the camera when outdoors has sufficient protection
(e.g., heated, weatherproof housing).
8.
After completing your settings, push the protective cover over the keypad and seal the
position with the sticker supplied. (Note: The sticker can only be used once.)
Threaded hole
Fixing
screw
Use cable clips to ensure sufficient
pull relief of connection cables.
11. Technical data
Model number
CCD element
Number of pixels
TV lines
AGC range
Gamma correction
Light sensitivity
Signal-to-noise ratio
Resolution
CTF modulation
Electronic shutter control
Video OUT
Power source
Power consumption
4.8W (DC) 6.0 W (AC)
Video norm
Lens holder
Dimensions / Weight
Ambient operating
temperature
Ambient operating humidity
Lens holder
VdS cert.:
VdS certification no. V105002 VdS certification no.: V105003
Environment class
55
TV7310
TV7311
1/3" Interlace SONY ExView CCD
752 (H) x 582 (V) pixels
500 TV lines (colour) 540 TV lines (B/W)
36dB
0.45 – 1
0.03 lux @ 30 IRE F1.0 (B/W mode)
0.07 lux @ 30 IRE F1.0 (colour mode)
35 lux @ 100 IRE at sensor (colour mode)
60 dB @ 100 IRE AGC Off
50 dB @ 30 IRE AGC Off
500 TV lines @ 100 IRE AGC Off (colour)
410 TV lines @ 30 IRE AGC Off (colour)
11% at output signal @ 500 TV lines
1/50s – 1 / 100,000s
2 x 1Vp-p / 75 Ohm / BNC plug connector
12VDC or 24VAC
85 ~ 265V AC
6.0 W (AC)
PAL
1/3" C or CS mounting
H: 52 x W: 71 x D: 140 mm / 345 g
-10 °C – +50 °C
max. 90 % non-condensed
C/CS holder
II
Advertenties
Hoofdstukken
Inhoudsopgave
