Inhoudsopgave
Advertenties
28
Maintenance and Service
EN
Failure
The machine is working
but it doesn't cut well
USER MANUAL
Reason
• Air pressure and flow may not be
suitable, air filter elements may be
dirty
• Torch and/or consumables may be
worn or damaged
• Torch and/or consumables may not
be correctly selected or installed
• The cut mode may be incorrectly
selected
• The amperage value current used
may be incorrectly selected
• The cutting speed and thickness
suitable for the performance of the
machine may have been exceeded
• The height or angle of the torch to the
workpiece may be incorrect
• The cutting direction may be incorrect
ID 65 PX / ID 65 P
• Check the air pressure and air
Solution
quality. Make sure that the air
pressure and flow rate are
appropriate, the air is dry and clean
• If the problem continues, contact the
authorized service
• Make sure the torch and / or
consumables are not worn or
damaged, replace if necessary
• If the problem continues, contact the
authorized service
• Make sure torch and / or
consumables are used and installed
correctly
• If the problem continues, contact the
authorized service
• Make sure the cut mode is correct
• If the problem continues, contact the
authorized service
• Current value should be selected
suitable for the material to be cut
(material thickness and type)
• If the problem continues, contact the
authorized service
• Make sure the cutting speed and
cutting thickness are appropriate
• If the problem continues, contact the
authorized service
• Make sure the height and angle of the
torch to the workpiece are correct
• If the problem continues, contact the
authorized service
• Make sure that the cutting direction
is correct
• If the problem continues, contact the
authorized service
www.magmaweld.com
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
