Inhoudsopgave
Advertenties
Display
1. Command indicator of function buttons
A1 or B1
2. Command indicator of function buttons
A2 or B2
3. Transmission indicator
4. Current button setup indication
5. Battery power indicator
6. Indicator of mode or stimulation level
7. Locking of selected function and command
5.2 Receiver
1. Contact points
2. Strap
3. Target (red indicator) indicating
where the ON/OFF magnetic
switch is located
4. LED indicators
6
6.1 Battery insertion and replacement
1. Screw out 4 screws from the battery cover using a cross-head screwdriver and
remove the lid.
2. Insert two alkaline AAA batteries into the battery compartment with a correct
polarity (according to the polarity indicated with the "+" symbol in the battery
compartment). Wrong polarity may damage the unit.
3. Make sure that the rubber seal is clean and correctly seated in its groove.
4. Put the battery cover back and screw in the 4 screws adequately.
6.2 Checking the transmitter battery status
The battery power indicator on LCD shows the battery status:
– Fully charged battery
– Medium charged battery
– Flat battery
If the battery is flat, insert new AAA alkaline batteries into the battery compartment.
1
2
3
4
TRANSMITTER PREPARATION
1
2
7
4
3
5
6
25
Advertenties
Hoofdstukken
Inhoudsopgave
