Inhoudsopgave
Advertenties
EN
•
Point the jet from the spray gun at the
bottom edge of the previous stroke,
so that each stroke overlaps by 50%.
1.
Start moving the spray gun
2.
Press the trigger
3.
Continue moving the spray gun
4.
Release the trigger
5.
Stop moving the spray gun
6.
Point here with the spray gun to overlap
the previous stroke by 50%
7.
Release the trigger before the stroke is
finished
8.
Press the trigger after starting the stroke
FIG. 9
Spray pattern and quality
The material is spread smoothly over the
surface when the spray pattern is correct.
•
The material should be finely dispersed
and uniformly applied, without gaps at
the edges.
•
Adjust the pressure control knob (8) until
the spray pattern is uniform, without gaps
or thicker layers at the edges.
•
If it is not possible to correct the spray
pattern, check whether the nozzle is worn.
The material may need to be diluted.
Follow the instructions of the material
manufacturer for dilution.
CLEANING THE NOZZLE
If the nozzle gets blocked during the spraying,
turn the nozzle to quickly and easily clear away
the particles without dismantling the product.
1.
Apply the trigger lock and turn the nozzle
to the cleaning position. Check that the
nozzle is inserted all the way in the nozzle
guard.
2.
Release the trigger lock, point the spray
gun down in the container and press the
trigger for 2 seconds.
50
3.
Apply the trigger lock, turn back the
nozzle to the spraying position, release
the trigger lock and continue spraying.
CLEARING A BLOCKAGE
Follow the instructions below if no material
comes out through the spray gun, or if you are
not certain that the pressure was fully relieved
when the process for relieving the pressure was
carried out.
1.
Release the high-pressure hose very slowly
from the spray gun.
2.
Put the pressure relief valve lever (6) in its
horizontal position.
3.
Hold the hose in a firm grip and point the
end down into the material container.
Put the switch (1) in the on position.
4.
If no material flows out through the hose,
connect the hose again and continue with
step 6.
5.
If material flows out through the hose,
follow the instructions for cleaning the
spray gun and filter.
6.
Connect the hose to the spray gun and
follow the instructions for preparations
before spraying.
MAINTENANCE
Follow the maintenance instructions for best
functionality and useful life.
•
Check and clean the inlet filter and spray
gun filter before use.
•
Replace the filters if they are damaged or
if they cannot be cleaned.
•
Check the product for leakage, especially
at the connections. Replace any damaged
parts.
•
Always check the high-pressure hose for
damage before use. Damaged hoses and
connections must be replaced – never
attempt to repair them.
Advertenties
Inhoudsopgave
