Download Print deze pagina

Troubleshooting; Technical Characteristics - Mottura SOFTBOX 437 Handleiding Voor Bediening En Installatie

Verberg thumbnails

Inhoudsopgave

Advertenties

3. Run the system up and at the same time turn the UP limit switch screw in the "

system stops. If the system goes beyond the UP limit switch position required without stopping, proceed

as follows:

A) stop the system

B) run the system down, and without touching the UP limit switch, take the blind down to half way

C) run the system up and at the same time turn the UP limit switch screw in the "

the system stops. If necessary repeat the operation from point A

4. Once the UP limit is reached, the system stops. At this point, if the position needs to be corrected, then:

• to shorten the travel of the blind:

D) run the system down so the blind drops by a few cms

E) turn the UP limit switch screw a few turns in the "

F) run the system up and see where the system stops. If necessary repeat the operation from point D

• to lengthen the travel:

G) with the system stopped at the UP limit switch and not supplied with power, turn the UP limit

screw a few turns in the "

H) run the system up and see where the system stops. If necessary repeat the operation from point G

5. Once the UP limit switch has been corrected, check that the system works properly by moving the

system in both directions until it stops at the limit switches.

FAULT

The system does not move

The system does not stop

at the correct position

Voltage: 24 VDC

Current: 0,3 A

Power: 7,2 W

Torque: 2 x 0,4 Nm (Softbox 437 - Qbox 457 – Plì 353/4)

Revolutions: 42 RPM (Softbox 437 - Qbox 457 – Plì 353/4)

Limit switch capacity: 60 turns

Length of power lead: 3 m

" direction