Inhoudsopgave
Advertenties
Maintenance
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
Pull out the power plug.
Do not touch running blades.
Never spray down the lawnmower using water, especially not
at high pressure.
Regularly check and tighten all visible screws and nuts, espe-
cially those relating to the cutting bar, to ensure a firm fit.
Always have blades changed or re-sharpened by a specialist
workshop, since a balance test must be carried out as speci-
fied in the safety regulations following any removal of parts.
Assembly
Fasten handle bars
A
B
1
Caution!
The cable can be damaged while folding up or pulling out
the handle bar.
Inlay the cable in the bend protection
When adjusting the handle height take care that the ca-
ble is not crimped
C
1. Fold the bottom part of the handle up and screw it tight with
the two hand wheels
B
.
2. Set the handle to the desired height
3. Fold the upper part of the handle out and screw it tight with the
wing nuts
D
.
Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
Please feed cable through the strain relief
3
Note: WOLF Flick-Flack®
WOLF Flick-Flack® keeps the cable away from the cutting
J
unit
.
Hang up collection bag
K
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Do not attach the collection bag until your feet are at a
safe distance from the cutting tool.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the reces-
ses (see arrow).
3. Replace the protective flap.
12
All manuals and user guides at all-guides.com
C D
A
.
C
.
H
H
.
Only use original WOLF spare parts. Otherwise we can't gua-
rantee that your mower conforms to the safety regulations.
Never park your lawnmower in damp rooms.
For safety reasons, replace worn or damaged parts.
Disposal
Do not dispose of electrical equipment in domestic
waste. Recycle equipment, accessories and pa-
ckaging in an environment-friendly manner.
Mount the collecting bag
1. Place the chute (1) on the collecting bag flap (2)
2. Press the chute from behind onto the collecting bag flap. The
chute is ready for use as soon as it locks into place
Set cut height
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
Switch off motor and pull out power plug.
1. Pull the lever out
L
.
2. Set the desired cutting height
3. Press the lever back in
N
.
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do
not se cutting position too low when mowing very hight or wet
grass.
We recommend an average cutting height of 40 mm.
E
F
G
E
F
.
G
.
M
.
G
Advertenties
Hoofdstukken
Inhoudsopgave
