Advertenties
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration values
Total vibration (during operation) (a)
Uncertainty (K)
Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶
Before inserting the battery, make sure that the product is switched off.
▶
Remove the battery before making any adjustments to the power tool or before changing accessories.
WARNING
Risk of injury! If not aligned flush, lever and pivoting bar can fly out like projectiles.
▶
Before and during the crimping operation, make sure that lever and pivoting bar are correctly aligned.
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶
Wear protective gloves when changing the accessory tool.
▶
Never lay down a hot accessory tool on a flammable surface.
Observe the safety instructions and warnings in this documentation and on the product.
Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶
Before inserting the battery, make sure that the contacts on the battery and the contacts on the product are free of foreign matter.
▶
Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
Switching starting lock on/off
The crimping tool has a starting lock that can be optionally activated or deactivated. If the starting lock is activated, the control switch has to
be pressed twice to start the crimping operation. This prevents inadvertent starting.
The factory default is starting lock deactivated.
1. Remove the battery.
2. Press and hold down the control switch.
3. Insert the battery into the crimping tool.
4. Release the control switch.
▶
The green LED flashes twice; acoustic signal sounds twice: starting lock activated
▶
Green LED flashes once; acoustic signal sounds once: starting lock deactivated
16
)
pA
)
pA
14
16
69 dB(A)
1.5 dB(A)
< 2.5 m/s²
1.5 m/s²
21.6 V
See the end of these operating instructions
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
*2321724*
2321724
Advertenties
