Inhoudsopgave
Advertenties
maintenance
extractor hood
Clean the extractor hood as soon as the grease filter
indicator light comes on.
The stainless steel on the outside of the hood can be
cleaned w ith soapy w ater and a damp cloth. The stainless
steel w ill regain its shine if you occasionally use a stainless
steel care product or polish. The polish imparts a dirt-
resistant layer to the stainless steel. Alw ays clean the
stainless steel in the direction of polishing.
Never use abrasive cleaning agents (such as Vim, green
scouring pads or other scourers) or polishing cleaning
products (such as liquid scourers and Jif).
Never use caustic cleaning agents. These can cause
stainless steel to discolour.
GB 6
maintenance
(continued)
removing/replacing grease filters
Remove the filters as follow s: sw itch the fan and the lighting
off.
Push the filter at the edge of the niche to the back and pull
the front end dow n. You can now remove the filter from the
hood.
The filter can only be put back into place in one w ay. Take
note of the correct position of the filter (see illustration).
Hold the filter in such a w ay that the covered part of the
underside is at the centre rear. This is recognizable on the
outside by the pattern w ith the smaller holes.
Put the filter back into place by first pushing the rear side
into the holder. Then push the front upw ards until it cannot
go any further and let the filter slide forw ards. The filter is
now once again in place. Erase the electronic memory by
pressing the
cleaning the grease filters
You can clean the grease filters in the dishw asher. Allow the
filter to drain w ell - through the slits in the side - before
putting it back.
replacing the carbon filter
Replace the carbon filter tw ice a year. This only applies to
recirculation hoods.
Put the carbon filter in the place intended for it above the
filters.
button for approx. 5 seconds.
GB 7
Advertenties
Hoofdstukken
Inhoudsopgave
