Overload Protection; Restart Prevention; Working Methods; General Working Instructions - Grizzly GHS 2842 B Vertaling Van De Originele Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor GHS 2842 B:
- Vertaling van de originele gebruiksaanwijzing (104 pagina's)
Inhoudsopgave
Advertenties
Overload protection
In the event of overload, e.g. due to branches
that are too thick, the equipment automatically
switches off.
Restart prevention
After switching off automatically as a result of
overload, the equipment will not restart auto-
matically.
To switch back on, start by turning the operat-
ing mode selection switch (
position.
Press the reset switch (
Switch the device back on.
Working methods
General working instructions
Keep enough distance to the shredder
since long branches can be spun off
while being drawn into the shredder.
Wear ear and eye protection
Wear hand protection
•
For safety reasons, the shredder will not
operate without a correctly attached col-
lector box (
11).
A
•
Keep hold of branches while feeding them
into the shredder until they are automati-
cally drawn in.
•
Be aware of the possible intake speed of
the cutter and do not overload the equip-
ment.
•
Keep to the working speed of the shred-
der and do not overload it.
•
To protect the shredder from clogging,
shred wilted garden waste that has been
left for a few days and shred thin twigs
alternately with branches.
•
Before you shred roots, remove any re-
All manuals and user guides at all-guides.com
2) to the "OFF"
A
1).
A
maining soil and stones from them
•
Do not shred soft, damp material such as
kitchen waste, but take it straight to the
compost.
•
Keep a few dry branches for the end, as
they will help clean the shredder.
•
Only switch the shredder off when all of the
shredding material has passed through the
cylinder. Otherwise, the cylinder may jam the
next time you switch the shredder on.
Freeing up a jam
•
Push back the operating mode selection
switch (
2) lock and turn the operating
A
mode selection switch to the left.
The operating mode selection switch does
not lock into place.
1
Jammed chopping material is released.
The direction of rotation is to be changed only
until the chopping material is released.
•
For stubborn blockages, the distance of
the pressure plate from the blade cylinder
can be increased by turning the adjusting
screw (
8) anticlockwise. To switch the
A
device back on, turn the operating mode
selection switch (
chopping material has been released, the
pressure plate must be readjusted by turn-
ing the adjusting screw (
Exceptionally, if this process fails to re-
move the blockage, the following option
remains:
1. Remove the four Allen screw (15) on the
housing plate (16).
GB
2
2). When the jammed
A
8) clockwise.
A
81
Advertenties
Hoofdstukken
Inhoudsopgave
