Operation; Start-Up; Switching The Shredder On And Off; Changing The Rotation Direction - Grizzly GHS 2842 B Vertaling Van De Originele Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor GHS 2842 B:
- Vertaling van de originele gebruiksaanwijzing (104 pagina's)
Inhoudsopgave
Advertenties
GB
Operation
Start-up
Before starting the shredder, make sure
that the shredder unit is firmly attached to
the chassis and the collector box and safety
switch are in their proper positions.
The shredder cannot be switched on
before the collector box and safety
switch are in their proper positions.
Switching the shredder on and off
Make sure that the mains power vol-
tage agrees with the type plate on the
shredder.
Make a loop at the end of the
extension cable and hang the
loop onto the strain relief on the
mains cable (
Connect the extension cable.
Make sure that the funnel feeder is empty.
1. To switch on, push the operating mode
selection switch (
turn the operating mode selection switch
to the right.
The operating mode selection switch
locks into place.
2
1
Place your chopping material in the fill hopper.
The material is drawn in and chopped.
2. To switch off, turn the operating mode se-
lection switch (
80
All manuals and user guides at all-guides.com
6).
A
2) lock forward and
A
2) back to the left.
A
The shredder will continue to run immedi-
ately after switching off.
Changing the rotation direction
The rotation direction can be changed.
•
Push back the operating mode selec-
tion switch (
operating mode selection switch to the
left.
The operating mode selection switch
does not lock into place.
1
Jammed chopping material is released.
The direction of rotation is to be changed only
until the chopping material is released.
Emptying the collector box
Do not leave it until too late to empty
the collector box. Remember that the
collector box fills unevenly under the
ejector opening.
1. Switch the shredder off.
2. Unlock the collector box (
the safety switch (
tion.
3. Remove the collector box (
chassis (
9) and empty it.
A
4. Make sure that the area around the safety
switch (
10) is free of wood chippings
A
before you reattach the collector box
(
11).
A
5. Reattach the collector box and place the
safety switch in the ON position.
2) lock and turn the
A
2
11) by placing
A
10) in the OFF posi-
A
11) from the
A
Advertenties
Hoofdstukken
Inhoudsopgave
